Human Touch HT-7450 Manual de usuario descargar pdf

REPLACING THE HT-7450 AIR PUMP TUBING

FITTING

12/27/08

HT-7450

Tools Required: Phillips-head screwdriver, nail clipper or other instrument suitable for cutting zip ties,

new zip ties, small needle-nosed pliers, large paper clip

NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

REMOVING THE FITTING

1. Power off the chair and unplug it.

2. Locate the backrest connection panel on the back of the left-hand armrest, then unplug the top connector (Fig.1).

3. Locate the fitting piece that broke off and, if possible, remove it. It is most likely lodged in the fitting receptacle

on the backrest connection panel. You may need to bend a large paper clip as shown in Fig.2, then use this tool to

dislodge the broken fitting piece from the receptacle (Fig.3).

(Fig.1)

Top connector

To ensure that Human Touch

products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all

product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

SERVICE LEVEL: 2

Fitting

Large paper clip

Broken ﬁtting piece

(Fig.2) (Fig.3)

1 2

REPLACING THE HT-7450 AIR PUMP TUBING FITTING 12/27/08HT-7450Tools Required: Phillips-head screwdriver, nail clipper or other instrument suitable for

2INSTALLING THE NEW FITTING1. Place the new fitting into the air pump tubing connector, and secure it using the two screws.2. Connect the air pump t

Sin comentarios

Human Touch HT-7450 Manual de usuario